Free 3d slicers for cr 10 install#
Free 3d slicers for cr 10 serial#
Free 3d slicers for cr 10 manual#
Free 3d slicers for cr 10 upgrade#

Slowly turn the knob to lower the nozzle close to the bed.

Select Move 10mm (This will set the nozzle tip approximately 10mm above the bed.).

(The machine will go through a bed level routing where the BL Touch probe will touch multiple locations on the bed.).

(all further instructions are done on the CR-10 and not the slicer) Make sure the firmware is properly installed prior to going any further. If it does not, then something went wrong with the firmware update. The ready screen should show вЂњCR-10 V2BL Touch ReadyвЂќ and the menus should show the new BL Touch settings.

Free 3d slicers for cr 10 manual#

The installation manual only shows the hardware installation and is detailed enough to get you through this step. Make sure there is enough slack in the wire to allow the extruder head to move all the way from left to right.

Free 3d slicers for cr 10 install#

Install the BL Touch hardware and wires as per the instructions in the manual.

Use a cable tie to secure the wires that went to the Z home switch so it does not get caught on the table when it is travelling.

It will no longer be needed because the BL Touch will now sense the Z height(s.)

Remove the original Z home switch from the CR-10.

After you are certain that the firmware has been installed correctly turn off the machine.

The new firmware will flash to the CR-10.

Navigate to the file location where you saved the appropriate firmware for the CR-10 V2 with BL Touch and select the firmware and OK.

I have read that you should select the highest COM port that appears however my highest was COM 3 so I selected this.

Free 3d slicers for cr 10 serial#

Select COM 3 Serial Port under Communications.There may be a way to use Cura or other slicers to download the firmware however it is probably best to use the Creality slicer for this. Install the new firmware onto the Creality CR-10 V2:.Turn on the CR-10 V2 and attach to your computer with the appropriate USB cable.Make sure that if you are just installing the BL Touch sensor to just download the BL Touch firmware and NOT the BL Touch with the Titan direct drive extruder unless you are installing the direct drive extruder as well. Download firmware from CrealityвЂ™s website.

These are just the steps that I took and though it may be helpful for others.Д¬reality CR-10 V2 BL Touch Installation & Setup Instructions Please do not take the following steps as gospel and I am not responsible for any damage caused if you do follow these instructions. Once I finally figured it out and had it working I wrote down the steps that I went through. The video is helpful but there are some steps and explanations left out.

Free 3d slicers for cr 10 upgrade#

They are easy, quick and convenient to assemble right out of the box.So I purchased the BL Touch upgrade for the CR-10 V2 and quickly found out that there are not a cohesive set of instructions available on Creality's site. It comes with a separated LCD control box, SD Card support for offline printing as well as a USB adapter cable for linking it to computers. A biggest highlights of CR 10Series is its bigness and price range of $300-$400. Large build area of 300x300x400mm and features a quality glass print bed coming with well-rounded edges and is a perfect fit for the aluminum plate below. We hope to create a large community of users who contribute to the project, ultimately resulting in a better product for all.Д¬reality CR Series features a linear bearing system, along with the extruded aluminum struts, the V-Slot' wheels offer excellent dimensional stability even during extended use, works well to provide a smooth and steady motion system that reflects in the high quality of prints. Open Source: In the spirit of innovation and progress, we have decided to make our firmware and design plans available to all for extensive modding and improvements.